1. Brand new and high quality
2. Microwave radar sensor 3. No need wiring easy for installation 4. Mini size patented 5. Solar panel: 0.55W 5.5V 6. Output power: 2W 7. Working current: 400mA 8. Li-ion battery: 3.7V 1000mAh 9. LED: 16 LEDs SMD2835 LED 10. Material: alluminium alloy + stainless steel 11. Lighting mode: radar sensor with weak light 12. Response time: 15s 13. Charge time: 6 hours 14. Lighting time: more than 500 times after full charged Precautions: 1. The probe of the microwave detector should not be aimed at objects that may be active. 2. It is forbidden to be installed indoors because the microwave has a penetrability to the nonmetal and the indoor activity may cause false induction. 3. There should be no excessive too thick objects especially metal bodies in the detection area otherwise a blind spot will be generated behind these objects. 4. Microwave detectors should not be aimed at fluorescent lamps mercury lamps and other gas discharge light source. Fluorescent lamp directly generated by the 100Hz modulation signal will cause false induction especially in the event of a flickering fluorescent lamp is causing interference. This is because in the flashing lights within the ionization of gas is to become a microwave to the reflector caused by false positives. 5. Should not be installed indoors. 6. In the same position need to install more than two microwave detectors are prone to cross-interference the occurrence of false induction so the microwave transmission frequency between them should be different generally about 25MHz difference and not relative placement. Be sure to install more than two be sure to be separated from each other more than 2 meters. |
|