Material:Stainless Steel
Product parameters:
Working rod: 47cm
Support rod: 41.5cm
Operating lever: 39.5cm
Noodle barrel: 12.5x5.7cm
Weight: 5.4kg
Noodle bucket off the ground: 25cm
Carton size: 41.5x25.5x12cm
Operating space: no less than 80cm
Four face cutter heads: 1mm aperture 2x6mm aperture 2mm aperture 3mm aperture

Operation method:
Step 1: the whole installation of the noodle machine first put the base positively and then align the support rod frame at the position where the base has screw holes.
Step 2: After aligning put the screw on the screw hole put the screw and then press the screw to roll the base and the support bar together to prepare the screw. When the screw is on we can focus on it and so on. This ensures the installation process. The stability is good. After tightening the nut tighten it and put it straight.
Step 3: Place the handle on the top of the support bar. Hold the handle of the operating frame with one hand and place the gasket on the top of the support bar with one hand and then put the upper semi-circular nut on the equipped wrench. Here our pasta machine is basically formed.